Broke the existing clip and instead of going to the wreckers looking for a replacement, why not print one?
This one works ok, if it breaks again I will be narrowing the mouth of the holder, lowering it and putting in some supports to make it's grip a little stronger.
Width of the "C" that holds the whole clip in place could also be a little wider to prevent it sliding left to right. Don't think it needs reshaping to get a better grip on the car.
May fit other years and models.
Hopefully I've designed the scad file so that it can be tweaked without too much stress.
-edit 2014 09 25-
Minor changes to give the clip and insert a little more strength.
| ForesterHoodClip.scad | 2.0KB | |
| ForesterHoodClip.stl | 125.4KB |
