2 Slot Hot Glue Gun Holder 3D Printer Model
The file '2 Slot Hot Glue Gun Holder 3D Printer Model' is (stl,dxf,f3z) file type, size is 672.6KB.
The file '2 Slot Hot Glue Gun Holder 3D Printer Model' is (stl,dxf,f3z) file type, size is 672.6KB.
This is a 2-slot glue gun holder for Dremel glue guns and some weird glue guns with a bad base.
The assembly is made of 1/8in thick plywood however other materials could probably be used but don't make it out of anything that will melt. Each stand will need a little under a 12in by 20in sheet of material. The cardboard insert is modeled to 1/4in thick but the thickness can be whatever you have on hand.
!!!NOTE!!!
the BaceCordRap comment is directional and should not stick out from the edge of the model. Also, make only the base plate and holder 1st to check if your glue gun will work. Alternatively, rest your glue gun on a table and rest your finger 2.5 inches above the table and check to see if your glue gun balances.
To make one holder you will need to cut out the following,
1 Baceplate
1 Holder
2 baseCordRap
3 Side
1 CardBord_insert
I am a novice designer so any critiques on this page would be much appreciated.
| bace.stl | 72.5KB | |
| baceCordRap.dxf | 3.6KB | |
| baceCordRap.stl | 24.9KB | |
| baceplate.dxf | 13.1KB | |
| cardbord_insert.dxf | 2.6KB | |
| cardbord_insert.stl | 7.7KB | |
| guleholder_v4.f3z | 611.5KB | |
| guleholder_v4.stl | 140.1KB | |
| holder.dxf | 4.6KB | |
| Holder.stl | 39.1KB | |
| side.dxf | 3.2KB | |
| side.stl | 5.4KB |
![Y-axis Linear Bearing [624zz] 3D Printer Model](https://cdn.3axis.co/assets/cd/d0/ee/4a/cdd0ee4a-b50d-4de1-9f6c-a974d3522136/images/b42d89b3-ef6a-4bba-b236-7f5a20f5d98d_thumb.jpg)
