2″ & 3″ Bases – Depths Of Savage Atoll 3D Printer Model
The file '2″ & 3″ Bases – Depths Of Savage Atoll 3D Printer Model' is (stl) file type, size is 65.4MB.
The file '2″ & 3″ Bases – Depths Of Savage Atoll 3D Printer Model' is (stl) file type, size is 65.4MB.
I recently created a bunch of different bases for my Kickstarter Depths of Savage Atoll, and thought I would share some back to the community!
This second release is a bunch of the larger (2" and 3") bases. My bases are unique in that they have a bevel and "ring" on the bottom - designed to allow you to easily paint a black (or colored) ring on the bottom, as your brush follows the bevel. Included in this release are listed below. A few of these are flat so are idea for glueing critters to, some were designed for specific models but I thought folks could still get some use of out them!
If you need 1" bases you can see that release HERE
| 2_-_Jungle.stl | 18.4MB | |
| 2_-_Plain_Sand_1.stl | 10.7MB | |
| 2_-_Plain_Sand_2.stl | 10.4MB | |
| 2_-_Rocky_Sand.stl | 13.3MB | |
| 2_-_Rock_and_Coral_Sand.stl | 25.2MB | |
| 2_Base_-_Temple.stl | 5.8MB | |
| 3_-_Jungle.stl | 21.3MB | |
| 3_-_Rocky_Sea_Floor.stl | 22.9MB |
