This project took me longer to print, than to design it. It is a modular train depot with a turn-table. It took me about 3 weeks of almost non-stop printing to do what you see.
I still have some works on the turn-table and the bridge - it is designed to be controlled by a stepping motor and Adruino.
I'm also finalizing the sliding doors for each cell, as well as the end buffers - files are missing at this point.
I had some printing issues with the windows - afte 27 hours of printing and 1/4 roll of filament, I discovered, that some windows were damaged. I did not want to re-print the whole thing again, so I cut out all windows (100 pcs for a 10 cell depot) and designed separate window frame. Since I had a long a difficult paint job, It turned out better to have separete window frames, printed in different color - saved a lot of painting time.
If you don't plan to make electric rotation and train movement, I guess, you could print it the way it is.
Stay tuned as project goes on.
| building_big_left.stl | 42.2MB | |
| building_big_MID.stl | 29.0MB | |
| building_big_right.stl | 42.5MB | |
| building_small_LEFT.stl | 3.8MB | |
| building_small_MID.stl | 1.3MB | |
| building_small_RIGHT.stl | 3.7MB | |
| depot.pdf | 1.0MB | |
| door.stl | 936.7KB | |
| door_frame.stl | 484.8KB | |
| fence_BAR.stl | 20.4KB | |
| fence_CABIN.stl | 60.0KB | |
| fence_LEFT.stl | 726.4KB | |
| fence_RIGHT.stl | 726.4KB | |
| roof_BIG.stl | 944.3KB | |
| roof_BIG_with_hole.stl | 997.9KB | |
| roof_SMALL.stl | 298.5KB | |
| roof_window.stl | 407.0KB | |
| window.stl | 65.9KB | |
| _in_progress_ramp.stl | 2.3MB | |
| _in_progress_table.stl | 80.6KB | |
| _in_progress_table_CROWN_1.stl | 182.9KB | |
| _in_progress_table_CROWN_2.stl | 214.3KB | |
| _in_progress_table_CROWN_3.stl | 254.7KB | |
| _in_progress_table_CROWN_4.stl | 229.6KB | |
| _in_progress_table_DISK.stl | 80.6KB |
