18650 Powered DP30V5A Bench PSU 3D Printer Model
The file '18650 Powered DP30V5A Bench PSU 3D Printer Model' is (stl) file type, size is 114.2KB.
The file '18650 Powered DP30V5A Bench PSU 3D Printer Model' is (stl) file type, size is 114.2KB.
This is a remix of https://www.thingiverse.com/thing:2120173 however it is actually a complete ground-up redesign from scratch in Fusion 360 using the source "thing" as a reference for sizes.
This version is improved with the ability to run the PSU from 3x 18650 batteries, or a hobby battery from something like a model RC helicopter.
1x DP30V5A - https://www.ebay.co.uk/itm/272718281609
1x 4mm Bannana Jack Set - https://www.ebay.co.uk/itm/264469858505
1x 16mm 12v Latching Button & Connector - https://www.ebay.co.uk/itm/1352395057455
1x XL6009 Step Up converter - https://www.ebay.co.uk/itm/262598327314
4x M3x20mm Grub Screws - https://www.ebay.co.uk/itm/174008149758
1x 5.5x2.5mm DC Female Jack - https://www.ebay.co.uk/itm/401763112690
1x 3S LiPo Protection PCB - https://www.ebay.co.uk/itm/192756798512
1x 3S LiPo Battery Meter - https://www.ebay.co.uk/itm/113890682728
You'll also need basic soldering supplies, such as some wire, solder, soldering iron, electrical tape, heatshink etc.
Im not going to provide a wiring diagram, if you're messing with LiPo's, you should be able to finish this one yourself.
One thing to note, there is a potentiometer on the Boost Converter PCB, set this to output something close to 35v so your DP30V5A can output that voltage.
The whole case itself goes together with Superglue.
| Back_Door.stl | 193.2KB | |
| Battery_Door.stl | 49.1KB | |
| Face_Plate.stl | 20.0KB | |
| Lid.stl | 108.9KB | |
| Main_Body.stl | 16.1KB |
