Battery case for 18650 battery cells in a 4S1P 2x2 configuration.
I used this with four Samsung 30Q cells to make a 15A 14.8V 3000mah pack for flying an FPV plane. I labelled it with this information but if you use different cells you might want to put a different label on it, so I've also included a blank case.
This case is specifically designed to have the cables exiting from the side as shown in the photos, so you will need to solder and route the cables appropriately.
The case and top have a small overlapping joint which should be glued together with CA. If you need to get in just break it apart and print a new top if needed.
| 4S1P_2X2_18650_Case.STEP | 1.7MB | |
| 4S1P_Case_-_3000mah.STL | 593.8KB | |
| 4S1P_Case_-_Blank.STL | 315.7KB | |
| 4S1P_Top.STL | 513.0KB |
