This is my first upload to Thingiverse!
This is a cable housing/holder for 16mm buttons designed to prevent the cables from being ripped out out from the button terminals. I designed it for the metal button linked below but it's a pretty general button design.
INSTRUCTIONS:
Once the cables are attached to their respective terminals, take a small zip tie (large zip tie not yet confirmed to work) and tie it about 15mm (3/4 inch) down the cable. Mount the button where you plan to use it and screw on the included nut. Next, thread the cable through the large hole of the housing and slide the housing onto the button. The cable will bend inside the housing and the housing will pressure fit onto the button.
| 16mm_Power_button_cable_housing.stl | 61.7KB |
