The file '150mm X 150mm Layer Height Calibration Test Pattern For Flashforge Adventurer 3 (Set General Layer Height And First Layer Height To .3mm) 3D Printer Model' is (stl) file type, size is 8.5KB.
This is a remix of an existing test pattern which has been resized and scaled for use with the Flashforge Adventurer 3 print bed.
When printing this test pattern, go into Flashprint 5 and set the General Layer Height and First Layer Height to 0.30mm before printing
I prefer this inter-connected test pattern over using a separate 9 square pattern because it's easier to remove from the print bed if you start from a good corner and work your way to the trouble corner. The Width and Length are stretched to 150mm x 150mm, and the height has been modified to be .3mm (roughly 75% of the .4mm diameter nozzle that ships with the Adventurer 3).
| Flashforge_Adventurer_3_150mm_x_150mm_Calibration_Grid_Set_General_Layer_Height_and_First_Layer_Height_to_0.30mm.stl | 37.3KB |
