12 Valve SOHC Supercharged V6 Engine 3D Printer Model
The file '12 Valve SOHC Supercharged V6 Engine 3D Printer Model' is (pdf,stl) file type, size is 3.9MB.
The file '12 Valve SOHC Supercharged V6 Engine 3D Printer Model' is (pdf,stl) file type, size is 3.9MB.
My custom designed 12 Valve Single Overhead Cam 90 Degree Supercharged V6. About 90 individual parts that need to be printed to put it together. Some sanding will be required to make the tight fitting parts fit. Pen springs can be used as valve springs. All of the parts were designed in Autodesk Inventor Proffesional 2024.
| 12_Valve_SOHC_90_V6_Engine.pdf | 690.8KB | |
| Block_ValveIntake_Pin.stl | 78.1KB | |
| Crankshaft.stl | 490.3KB | |
| Engine_Block.stl | 413.6KB | |
| Intake.stl | 286.4KB | |
| New_Camshaft.stl | 144.7KB | |
| New_Camshaft_Cap.stl | 15.2KB | |
| New_Camshaft_Cap_Rear.stl | 16.0KB | |
| New_Camshaft_Other_Side.stl | 144.7KB | |
| New_Valve.stl | 83.7KB | |
| New_ValveIntake.stl | 275.1KB | |
| New_Valvetrain.stl | 150.5KB | |
| Oilpan.stl | 84.3KB | |
| Oilpan_Engine_Block_Pin.stl | 81.9KB | |
| Piston_Headipt.stl | 61.7KB | |
| Rocker_Hinge.stl | 28.8KB | |
| Supercharger_Bottom.stl | 158.7KB | |
| Supercharger_Bottom_and_Top_Pin.stl | 82.5KB | |
| Supercharger_Intake_Engine_Block_Pin.stl | 85.0KB | |
| Supercharger_Rotor_1.stl | 3.0MB | |
| Supercharger_Rotor_2.stl | 2.7MB | |
| Supercharger_Top.stl | 391.7KB | |
| Supercharger_Top_Open.stl | 281.9KB | |
| Thick_Outer_Gears_Part_Smaller_Hole.stl | 125.9KB | |
| Thin_Inner_and_Outer_Gears_Smaller_Hole.stl | 206.7KB | |
| Thin_Inner_Gears_Part_Smaller_Hole.stl | 99.7KB | |
| Valve_Rocker.stl | 41.7KB | |
| Valve_Slider_Cam_Side.stl | 49.9KB | |
| Valve_Slider_Rocker_Side.stl | 31.4KB |
