UPDATE - 12ozCanCover-RemixV3-SingleTop-Repaired.stl I added small bumps in spots around the rim of the lid to help keep the spinning section in place. There are two "positions" fully open or fully closed.
I printed the original by carteram and liked the results but the hinge broke on my print (likely an issue with my filament. I took the hinge off and intended to use a piece of Gorilla tape to act as the hinge. I then decided to have a go at an option where the lid closes by turning it. I should have applied some ridges to the rim to lock it open or closed but I think this version is a workable prototype. It should snap together. I am printing it now and if anything is majorly wrong with the model I will provide an update.
| 12ozCanCover-RemixV3-SingleTop-Repaired.stl | 187.7KB | |
| Remix-Hingelesscan_topper.stl | 115.5KB | |
| Remix-Hingelesscan_topper_SpinToOpen.stl | 132.7KB |
