11th Civic Front Tweeter Adapter Bracket 3D Printer Model
The file '11th Civic Front Tweeter Adapter Bracket 3D Printer Model' is (stl) file type, size is 53.9KB.
The file '11th Civic Front Tweeter Adapter Bracket 3D Printer Model' is (stl) file type, size is 53.9KB.
This is a simple aligning bracket designed for replacing the OEM front tweeters on an 11th-gen (2022+) Civic with the Hertz C 26 OE tweeter, without the need to modify the A-pillar trim.
The bracket is specifically made for the C26OE, which has an outer diameter of 38.63mm, but it should also accommodate smaller tweeters with the addition of a gasket/tape around them.
Since it is not a structural component, it can be printed with a low infill ratio. I recommend securing the entire assembly with a bit of hot glue to the trim to prevent it from falling off or rattling.
| Honda_front_tweeter_to_C26OE.stl | 189.2KB |
![Honda Civic EK9 [G8D-240H-A] Remote Control Keyfob 3D Printer Model](https://cdn.3axis.co/assets/2d/07/da/6b/2d07da6b-6a62-4e3c-aba6-bf360939053f/images/56164047-4cd2-49e6-a559-d6551513000c_thumb.jpg)
