1:10 Scale Motorcycle Trailer 3D Printer Model
The file '1:10 Scale Motorcycle Trailer 3D Printer Model' is (stl) file type, size is 3.6MB.
The file '1:10 Scale Motorcycle Trailer 3D Printer Model' is (stl) file type, size is 3.6MB.
This is a 1:10 scale motorcycle trailer for use with scale RC vehicles such as the Axial SCX-10 II pictured.
Needed to complete assembly:
Blue threadlocker (I use Permatex gel)
Glue (I use 3D Gloop)
(18) M2 nuts
(5) M2 x 4 screws (hitch, front tire rack, fenders)
(4) M2 x 6 screws (axle)
(10) M2 x 12 screws (leaf spring mounts, swing shackle, leaf springs)
(2) M2 x 20 screws (axle stubs) (sub assembly pictured in gallery)
Instead of using threaded rod for an axle shaft I made axle stubs using M2 x 20 screws, M2 nuts, and the axle bearings (sub assembly pictured in gallery). The sub assembly is glued into the axle tube.
Tires, wheels, leaf springs, and fenders are files from @goodson_hobbies
https://www.thingiverse.com/thing:3853159
| MSMV2E3D_Axle.stl | 486.3KB | |
| MSMV2E3D_Axle_Bearing.stl | 71.2KB | |
| MSMV2E3D_Fender_left.stl | 560.8KB | |
| MSMV2E3D_Fender_right.stl | 560.8KB | |
| MSMV2E3D_Frame_front_section.stl | 115.1KB | |
| MSMV2E3D_Frame_mid_section.stl | 602.8KB | |
| MSMV2E3D_Frame_rear_section.stl | 336.1KB | |
| MSMV2E3D_Gear_Box.stl | 42.9KB | |
| MSMV2E3D_Hitch.stl | 659.9KB | |
| MSMV2E3D_Leaf_Spring.stl | 182.9KB | |
| MSMV2E3D_Leaf_Spring_Mount.stl | 792.7KB | |
| MSMV2E3D_Plate_front_section.stl | 1.2MB | |
| MSMV2E3D_Plate_mid_section.stl | 1.1MB | |
| MSMV2E3D_Plate_rear_section.stl | 1015.0KB | |
| MSMV2E3D_Ramp_bottom__section.stl | 8.3KB | |
| MSMV2E3D_Ramp_top_section.stl | 8.9KB | |
| MSMV2E3D_Swing_Shackle.stl | 4.6MB | |
| MSMV2E3D_Tail_Light.stl | 54.3KB | |
| MSMV2E3D_Tire.stl | 2.0MB | |
| MSMV2E3D_Tire_Rack_front.stl | 231.4KB | |
| MSMV2E3D_Tire_Rack_rear.stl | 170.4KB | |
| MSMV2E3D_Wheel.stl | 4.3MB |
