This is a 3-piece rim that I designed for my 1:10 MB jeep project, I decided to upload it separately since it can be used on any crawler.
The tyres in the photo are these, but the rims should work with any 1.9 tyres.
Tips are always appreciated and go straight back into buying parts to fund new projects, all of which get released for free.
Hardware Required
(5) M2x10mm screws
(5) M2 nuts
The nuts should fit in just right, but if the holes are too tight then just press them in with a hot soldering iron (or use a longer bolt to pull them into place, then replace with a shorter bolt).
| wheel_front.stl | 1.2MB | |
| wheel_rear.stl | 672.4KB | |
| wheel_ring.stl | 106.4KB |
