Thingiverse is still broken and not showing images in the listing pages. You can view images of my recent Things here: https://tinyurl.com/y4redcxv
I designed these 1" wall mount clips to display my favorite walking sticks I made from the Cane Topper remixes I've done.
There are a variety of clips so you can properly mount the various sizes of toppers. There are both screw mount and tape mount versions. I just tested this acrylic mounting tape for another project and it will hold a LOT of weight: https://www.amazon.com/gp/product/B07LDPQSVJ/
PLEASE NOTE: The 1", 1.5" and 2" offset 26mm clips will hold a 1" diameter cane/walking stick firmly if you want the tips to be off the floor. However, if you plan to take the canes in and out of the clips more than a few times - the clips will eventually break (with PLA anyway).
All the 28mm clips are a tad looser and allow the cane to slide up/down - so use these if you don't mind the tips touching the floor. These will probably last longer with repeated use.
If you don't want to put screws in your wall I've included the 1', 1.5" offset 26/28mm versions in tape mount.
In the photos, I've used the 1" offset but they are mounted on a 3/4" thick board so there is plenty of room between the topper and the wall.
PRINTING: No less than 30% infill for strength - I used 45% infill with PLA and that was pushing it as you loose the flex required.
| Cane_Clip_26mm_1.5_inch_offset.stl | 873.4KB | |
| Cane_Clip_26mm_1_inch_offset.stl | 873.4KB | |
| Cane_Clip_26mm_2_inch_offset.stl | 873.4KB | |
| Cane_Clip_28mm_1.5_inch_offset.stl | 873.4KB | |
| Cane_Clip_28mm_1_inch_offset.stl | 873.4KB | |
| Cane_Clip_28mm_2_inch_offset.stl | 873.4KB | |
| Cane_Clip_Tape_Mount_26mm_1.5_inch_offset.stl | 884.1KB | |
| Cane_Clip_Tape_Mount_26mm_1_inch_offset.stl | 884.1KB | |
| Cane_Clip_Tape_Mount_28mm_1.5_inch_offset.stl | 884.1KB | |
| Cane_Clip_Tape_Mount_28mm_1_inch_offset.stl | 884.1KB |
