Mag loads from the right side.
Print on it's back, so everything is nice and smooth.
10% infill is enough.
Use best quality like 0.12mm (it's a small and quick print, so make it nice and smooth)
Designed it as a tide fit , so no magnets are needed, but there is 3mm holes for some if you like. Magnet hole are designed for ball magnets, but if you drill the 0.5mm edge you will fit cylinder magnets too.
Pellet to be fed from both sides.
Obviously you need to hold the gun straight up (pointing forward) while loading the pellet or it may fell out.
When you drop the pellet take a look at it in the carnal to make sure it is facing forward and not in an angle.
All these seem to be the same PCP rifle:
Snowpeak P35
Artemis P35
SPA P35
SMK P35
Grizzly P35
This magazine may also fit Stoeger XM1 Bullpup / Bullshark (not tested).
| p35_magazine_1shot_v10.stl | 71.5KB |
