1 A Li-Ion Charger Case 3D Printer Model
The file '1 A Li-Ion Charger Case 3D Printer Model' is (obj,stl,x3d) file type, size is 10.2KB.
The file '1 A Li-Ion Charger Case 3D Printer Model' is (obj,stl,x3d) file type, size is 10.2KB.
This case is designed for a TP4056 1A LiPo/Liion charger that can charge 18650's batteries. To build this you will need additional parts.
After printing solder the wires of the positive and negative terminals of the battery holder to the according pads on the charger. Then insert the charger upside down into the printed case. Keep in mind that the wire of the positive terminal needs to feed through under the charger up to the front of the case. After that place the battery holder onto it and screw it in place. It helps to glue down some of the wires beforehand to make the assembly easier. You can choose to either use an M3 nut and screw or just any other screw that fits. I also trimmed off some parts of the battery holder, because the battery was held in too hard and when removing the battery the case could break.
| 1_a_charger_liion.obj | 24.0KB | |
| 1_a_charger_liion.stl | 16.3KB | |
| 1_a_charger_liion.x3d | 11.1KB |
